K150 PIC programming board

 

Overview
GIelectronic PIC-K150 programmer is a low-cost high-performance PIC programmer that supports the most popular PIC chip burning(write), read, encryption and other functions, its using high-speed USB communication mode, so that the programming speed is fast, stable and reliable. (average speed is higher than PICSTART + for about 3-5 times). It equipped with a 40pins ZIF socket, can be directly programmed the 8pin- 40pin DIP package PIC IC; for more than 40pins DIP package IC, it can be programmed via on-board ICSP interface. The manual of the PIC-K150 you find here.

The software is compatible with Windows 98, 2000/NT and XP or other operating systems.

Technical documentation & Design

This documentation was written August 25, 2004. This is the third in a series of three PIC Programmers designed by Tony Nixon. Most of the components – resistors, some capacitors, transistors and two IC’s – are surface mount and are pre-soldered on the board. There are 14 through-hole components for the buyer to solder.